By the time you see a stain or hear dripping, a burst pipe has often already been running for a while inside the wall.
Insulation and drywall removal is targeted, and we coordinate directly with a licensed plumber for the actual pipe repair.
We'll walk you through shutoff steps over the phone if you call before we arrive.
We use pressure testing and moisture tracing to locate exactly where a supply line failed inside the wall.
Drywall and insulation come out only where moisture readings confirm saturation, not the entire wall.
Handoff to a licensed plumber is built into our burst pipe process, not left for you to arrange separately.
A burst pipe call has a specific sequence — find the source, stop it, open only what's necessary, and coordinate repair — here's how our San Marcos, CA crews run it.
If the source is still running, shutoff is priority one.
Pressure testing and moisture tracing help pinpoint exactly where the line failed.
Wall cavity extraction addresses moisture a surface-level approach would miss.
We remove only the insulation and drywall sections that moisture readings confirm are compromised.
Drying continues until wall cavity moisture readings hit dry standard.
Plumbing repair coordination is included so you're not managing two separate contractors.
We'll walk you through locating the shutoff valve over the phone if needed.
Our nearest crew arrives ready to confirm shutoff and begin diagnostics.
You'll see the scope and cost once the failure point is confirmed.
We verify wall cavity moisture readings hit dry standard and confirm plumber repair is scheduled before closing the file.
"They found our shutoff valve in about thirty seconds since we had no idea it existed, then got straight to work on the wall." — Holly T.
"Only opened up the section of wall that was actually wet instead of the whole thing. Saved us a lot on drywall repair." — Andre L.
"They coordinated directly with our plumber so the pipe got fixed the same week the wall was already open." — Priscilla W.
We can confirm which you're dealing with during the initial assessment.
Only the compromised section comes out, not the full wall.
Pipe repair is handled by a licensed plumber we coordinate with, while we manage extraction and drying.
If you can safely reach it, shut off the water at the main or local valve to stop the flow.
Wall cavity drying typically takes 3-5 days depending on how much insulation and framing was affected.
If your address is in or near San Marcos, a crew can typically respond the same day.
Call now and we'll help you locate the shutoff valve over the phone if needed.
Call +1-844-578-1604